Fujitsu 2300 manual Off state, Changing System States

•Off state

All system functions are turned off to conserve power. The system does not respond to the pen or other input. The system boots at the next system power-on.

Note: The system consumes the same amount of power whether it is in Suspend-to-Disk mode or the Off state.

Your system may be configured to enter some of these states automatically after a period of inactivity to conserve battery power.

When you use the Stylistic 2300 pen tablet, you can change the current system state in a number of ways, depending on which state the system is in. To determine the current system state, observe the Power icon in the Status display. Table 2-1 gives the different system states represented by the Power icon and describes how you can change the system state from the current state.

Table 2-1 Changing System States

Power Icon	Current State	To Change State*
Appearance
Power icon	Fully On,	To enter the Off state, shut down the system.
displayed	Idle,
		To enter the Suspend-to-RAM or
continuously	or
		Suspend-to-Disk†state, suspend system
	Standby
		operation using either a hardware or software
		suspend.
Power icon	Suspend-to-RAM†	To enter the Fully On state, resume system
blinking		operation.
		To enter the Off state, resume system
		operation, then shut down your system.
Power icon not	Off	To enter the Fully On state, start your system,
displayed	or	or resume system operation.
	Suspend-to-Disk†

*Information in Table 2-1 is supplied to help you understand which system states your system can enter from the current system state. Refer to the procedures on starting the system, shutting down the system, suspending system operation, and resuming system operation given later in this chapter for details on changing the current system state.

†Your system may be configured to use either Suspend-to-RAM mode, Suspend-to-Disk mode, or may use both modes sequentially.

2-2 Using the Stylistic 2300 Pen Tablet