Elo TouchSystems 1925L Series manual Vesa Mount on Your Touchmonitor, Stand and Display Separation

VESA Mount on Your Touchmonitor

Your touchmonitor conforms to the VESA Flat Panel Monitor Physical Mounting Interface (FPMPMI™) Standard which defines a physical mounting interface for flat panel monitors, and corresponding standards for flat panel monitor mounting devices, such as wall and table arms. The VESA mounting interface is located on the back of your touchmonitor and is shipped pre-connected to the base.

Remove these four screws

(retain for reassembly)VESA mounting sufrace is located 8mm below the surface of the plastic.

Figure 2.4 Stand and Display Separation

NOTE: The above drawing displays the VESA mounting interface after the removal of the mounting cover and base.

NOTE: You will need a screwdriver for the following steps.

•Remove the four screws in order to separate the stand from the monitor (see Figure 1).

•Rotate the monitor 180° (ensuring the monitor will not be upside down when mounted in the position shown).

•Reinstall the four screws.

•Route the cables through the cutout (if applicable) and mount the monitor to the wall using the template in figure 2.

2-13