Elo TouchSystems 1925L Series manual Positional Accuracy

Page 42

Table 0.1 AccuTouch Touchmonitor Specifications

Mechanical

Construction

Top: Polyester with outside hard-surface coating with clear or

 

antiglare finish.

 

Inside: Transparent conductive coating.

 

Bottom: Glass substrate with uniform resistive coating. Top and

 

bottom layers separated by Elo-patented separator dots.

Positional Accuracy

Standard deviation of error is less than 0.080 in. (2.03 mm). This

 

equates to less than ±1%.

Touchpoint Density

Touch Activation Force

Surface Durability

Expected Life

Performance

More than 100,000 touchpoints/in² (15,500 touchpoints/cm²).

Typically less than 4 ounces (113 grams).

Meets Taber Abrasion Test (ASTM D1044), CS-10F wheel, 500 g. Meets pencil hardness 3H.

AccuTouch technology has been operationally tested to greater than 35 million touches in one location without failure, using a stylus similar to a finger.

Optical

Light Transmission

Typically 75% at 550-nm wavelength (visible light spectrum).

(per ASTM D1003)

 

Visual Resolution

All measurements made using USAF 1951 Resolution Chart, under

 

30 X magnification, with test unit located approximately 1.5 in. (38

 

mm) from surface of resolution chart.

 

Antiglare surface: 6:1 minimum.

Haze (per ASTM D1003)

Antiglare surface: Less than 15%.

Gloss (per ASTM D2457)

Antiglare surface: 90 ± 20 gloss units tested on a hard-coated front

 

surface.

 

 

C-38E l o E n t u i t i v e T o u c h m o n i t o r U s e r G u i d e

Image 42
Contents Page Elo Entuitive Touchmonitor User Guide Copyright 2004 Elo TouchSystems Inc. All Rights Reserved Table of Contents Precautions IntroductionAbout the Product Page Installation and Setup Unpacking Your TouchmonitorProduct Overview Side View Touch Interface Connection Serial/USB ConnectionTouchmonitor Connections Serial and USB Routing the Cables Connecting the Video Cables Connecting the Serial or USB Touchscreen Cable Connecting the Speaker Cable Optimizing the LCD Display Tilt Lock FunctionVesa Mount on Your Touchmonitor Stand and Display SeparationRear Mount Template Front Mount for Horizontal Surface Mounting the Base Security Kensington Cable LockInstalling the Driver Software Page Installing the Serial Touch Driver for MS-DOS and Windows Page Page About Touchmonitor Adjustments Using the On-Screen Display OSD MenusOperation Side Bezel Buttons Control FunctionOSD Menu Function Page Troubleshooting Solutions to Common ProblemsProblem Suggestions Page Native Resolution Input Video 19 LCDPage Touchmonitor Safety Care and Handling of Your Touchmonitor Technical Specifications Mode Resolution Frequency kHz Frequency HzCompatible Video Modes Touchmonitor Specifications LCD Touchmonitor ET19-XXxx-1 Specifications Mechanical OpticalEnvironmental Chemical ResistancePositional Accuracy LCD Touchmonitor ET192XL-XXWA-1 Dimensions 291 241 253 362 Aft tilt 90˚ from vertical Page Electrical Safety Information Regulatory InformationPage Page Page Warranty Page Index