Elo TouchSystems 1925L Series manual Connecting the Speaker Cable

Step 4-Connecting the Speaker Cable

Connections on underside

Speaker port

Speaker cable

NOTE: If you do not wish to connect the speaker cable, go to step 5.

•To use the built in speakers, you need to connect the speaker cable. Connect the speaker cable to the speaker port inside the back of your touchmonitor.

•Connect the other end of the cable to the speaker connector on your PC.

Step 5-Connecting the Power Cable

Connections on underside

IEC60320-1

connector

6mm coaxial connector

DC power

AC power (100-240V 50-60Hz or 12V DC)

Power cable

NOTE: The monitor is equipped with both AC and DC power connectors. The monitor is shipped with only an AC power cable.

Depending on where you live, you will use either the European or US/Canadian power cable.

•Connect the female end of the power cable to the power port on the touchmonitor.

•Route the cable through the cable management clip.

NOTE: To protect your equipment against risk of damage from electrical surges in the power line, plug the touchmonitor’s power cord into a surge protector, and then connect the surge protector to a grounded AC electrical outlet.

2-11