Linksys EFVCD20 manual Network

Page 11

EtherFast Series

Shutting Down

Reboot Select this to restart the Server upon pressing Start.

Shutdown now Select this to shut down the Server immediately upon pressing Start. After shutting down, the Server will not restart.

Shutdown in [ ] minutes This will start a delayed shutdown, upon pressing Start, with a maximum delay of 999 minutes.

Start Pressing this will begin the selected action.

Scheduling a Shutdown

Weekdays/Saturday/Sunday Select the appropriate check box for when you’d like to schedule a shutdown. Enter the time when you’d like the shutdown to occur, selecting am or pm from the pulldown menu.

Save Pressing this will save the scheduled data.

Network

The Network heading includes the following tabs:

TCP/IP - For adjusting IP address and related data, including the DHCP Server function.

DNS - For configuring DNS entries.

Microsoft Networking - For setting the Workgroup Name and Code Page.

Instant GigaCD Server

TCP/IP

This data was provided within the Setup Utility and can be adjusted here.

DHCP Client A DHCP (Dynamic Host Configuration Protocol) Server provides an IP Address to PCs and other devices on the network. This should be selected if you have a DHCP Server on your Network.

Fixed IP Address If Your Network does not have a DHCP Server, select this and enter the appropriate data in the following box.

IP Address This IP Address must be unused and compatible with the other devices on Your Network. This usually means that the first three fields should be the same as your PC and the last field should be an unused number between one and 254.

Network Mask This should be the same network mask used by the other devices on Your Network.

Gateway (Router) If Your Network has a Router or other Gateway, enter its IP Address here.

16

17

Image 11
Contents Instant GigaCD Server Copyright & Trademarks Introduction Table of ContentsInstant GigaCD Server’s Rear Panel Package ContentsSystem Requirements Instant GigaCD Server’s Front Panel Reset IP/Password Button10BaseT LED green Uplink ButtonBuzzer Installing Your Instant GigaCD ServerHardware Installation is complete Installing and Configuring the Setup SoftwareTCP/IP Server Administration Using the EtherFast Instant GigaCD ServerGeneral PasswordSystem Shutdown CopyNetwork Disk MicrosoftUtility Status UpgradeLog System Locating an Image File Managing Your CD ImagesOverview Creating an Image FileTo use Specify an IP address fixed IP Address Windows Client SetupTCP/IP Setup To act as a Dhcp ClientCommon Problems and Solutions TroubleshootingAppendix Linksys Warranty InformationCopyright 2000 Linksys, All Rights Reserved