Elo TouchSystems AMM17TK, AMM170TK, AMM18TK, AMM19TK manual Quick Start

Page 35

AMM170TK/AMM17TK/AMM18TK/AMM19TK/AMM19TK(HB) 35

Tounchscreen User's Manual (AMM17TK-TE/AMM18TK-TE/ AMM19TE orAMM17TK-TEW/AMM18TK-TEW/AMM19TK-TEW)

Quick Start

1.Connect Power Code and VGA Cable of LCD Monitor. 2.Connect Touchscreen DB9 male RS-232 cable. 3.Turn the LCD display Power ON.

4.Adjust the tilt of LCD Monitor. 5.Adjust the Picture of LCD Monitor.

6.Install driver software of Touchscreen (See "Driver software" for details).

7.Adjust the calibration of Touchscreen (See "Driver software" for details).

Introduction

The ELO IntelliTouch Touchscreen system consists of a touchscreen and an electronic touchscreen controller. The touchscreen may be a flat, spherical, or cylindrical and is installed over the face of the LCD. The touchscreen controller installed inside of theLCD.

The IntelliTouch Touchscreen

The IntelliTouch surface wave touchscreen consists of a glass panel molded to the precise shape of a display's face. A scratch-resistant, hard-coated plastic cover

sheet may be clear for best image clarity or have an antiglare finish.

The IntelliTouch Controller

The IntelliTouch controllers provide the drive signal for touchscreen, convert the received analogue signals into digital touch coordinates, and send these

coordinates to the computer.

Image 35

Contents Rev Revision ControlTable of Contents Press Properties to execute the Display Properties To change the resolution to its factory recommended presetScreen Adjustment Procedure To change the resolution to its factory recommended preset Press the Auto button on the monitor Introduction FeaturesUnpacking Symbol Explanations EU Declaration of Conformity for Medical Applications Screen Position Adjustment Cleaning Your Monitor Safety PrecautionOde Resolution H x Freq. KHz Freq. Hz Preset ModesOff Mode Power Management FunctionStand-by Mode Suspend ModeSteps InstallationDDC Video and Sound Connecting to a Television SignalStandard OSD Operation User ControlsFront Panel Controls OSD Scren Basic Section VGA Execute Recall Factory Default OSD Scren Basic Section DVI Push the select button to execute Recall OSD Scren Basic Section C-Video or S-Video Push the select button to execute Information Dpms OSD Function Description Under Analog DisplayIte m Function D e s cription OSD Function Description Under Digital DisplayDP M S OSD Function Description Under C-Video or S-Video DisplayLED OFF TroubleshootingAMM170TK SpecificationAMM17TK AMM18TK AMM19TK AMM19TK/HB Touch Port ConnectorsVideo Input Touch Screen Commencement and Duration of WarrantyPlace of Repair or Replacement Limitation of WarrantyTechnical Assistance Service InstallationQuick Start Touchmonitor installation Cable Connection AMM170TK/AMM17TK/AMM18TK/AMM19TK/AMM19TKHB