Regulatory Information

I. Electrical Safety Information:

A)Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer¡¦s label. Connection to a different power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.

B)There are no operator serviceable parts inside this equipment. There are hazardous voltages generated by this equipment which constitute a safety hazard. Service should be provided only by a qualified service technician.

C)This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet.

1)Do not substitute the cord with other than the provided approved type. Under no circum stances use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.

2)The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.

3)Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment to mains power.

II.Emissions and Immunity Information

A)Notice to Users in the United States: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

B)Notice to Users in Canada: This equipment complies with the Class B limits for radio noise emissions from digital apparatus as established by the Radio Interference Regulations of Industrie Canada.

C)Notice to Users in the European Union: Use only the provided power cords and interconnecting cabling provided with the equipment. Substitution of provided cords and cabling may compromise electrical safety or CE Mark Certification for emissions or immunity as re quired by the following standards: