Note that power to several system components must be restored before system operation resumes; allow sufficient time for system operation to resume before attempting to use the system. If your system uses
2. Use the system as you normally would once system operation resumes.
All programs resume at the point where execution stopped when system operation was suspended.
Charging the Battery Pack
The Stylistic 1200 battery pack can be charged while it is installed in the pen tablet. To do so:
1.Connect a DC power source, such as the AC adapter, to the DC input connector on the pen tablet. The DC Input icon appears in the Status display. If the battery pack charge level is below 90%, the battery pack begins charging and the Charging icon appears in the Status display. If the battery pack charge is 90% or higher when you connect DC power, the battery pack will not charge; this prevents overcharging the battery pack.
2.Look at the Battery Gauge icon in the Status display to determine the percent of charge in the battery pack. See “Status Display” in Chapter 1 of this manual for a description of the Battery Gauge icon.
As long as DC power remains connected to the pen tablet, the charging process continues until the battery pack charge reaches 100%. The amount of time needed to charge the battery pack is shown in the table below. Charge times shown here are for a fully discharged
| Battery Pack Charging Time | |
|
| |
Battery Pack Charge | Approximate Charge Time | |
| Level Reached | |
|
| |
|
|
|
90% |
| 3 hours |
|
|
|
99% |
| 4 hours |
|
|
|
100% |
| 5 hours |
|
|
|
The pen tablet uses two charge modes to charge the battery pack, Fast Charge mode and Slow Charge mode. When the charge level is below 90%, the system charges the
Charging the Battery Pack |