Peavey CA-A540B, CA-A800B manual Mains Power Source, Circuit Breaker

BACK PANEL CA-A800B

67

+ +	BUILT UNDER U.S. PATENT NO. 4,318,053		Cinem	coustics
	OUTPUT B	OUTPUT A
B A	+	+	CINEMA POWER AMPLIFIER
OUTPUT			10
MONITOR

400W/8 OHMS 56.6V RMS PER CHANNEL	dBV INPUT SENSITIVITY	dBV INPUT SENSITIVITY	ENABLE
700W/4 OHMS 52.9V RMS PER CHANNEL			DEFEAT

		1000W/2 OHMS 44.7V RMS PER CHANNEL	+15	+12	11	+15	+12	SPSTM
		+18		+9		+18	+9	8
				INPUT B	INPUT A
		+21		+6		+21	+6	9
		2 OHM MINIMUM LOAD		+3			+3
5								MODE
	RESET	CLASS 2 WIRING		- + + -				STEREO
								BRIDGE
				CA - A800B
		MOUNT IN RACK ONLY.		A DIVISION OF PEAVEY ELECTRONICS CORP
	120 VAC	INSTALLER SUR SUPPORT DE MONTAGE SEULEMENT		MERIDIAN, MS.		MADE IN U.S.A.
	60 Hz
	1500 WATTS
	4

(4) MAINS POWER SOURCE

All CinemAcoustics Series power amplifiers are fitted with a single, heavy-duty, three-conductor line cord and a conventional, three-terminal AC plug with a ground pin for 120 V products. For 100 V and 220 V products, the line cord is fitted with the appropriate power connector. The power plug should be connected to an independent circuit capable of supporting at least 15 amps for 100 V and 120 V service, and 7.5 amps for 220 V service. This is particularly important for applications where the amplifiers will be continuously operated at, or near, their maximum power rating. The use of extension cords should be avoided, but when necessary, use a three-wire type with at least a 14 WG wire size.

Always allow a qualified electrician to install any new electrical service. The ground pin of the power plug is provided for your safety and should not be defeated. To prevent the risk of shock

or fire hazard, always be sure that the amplifier is properly grounded.

NOTE: FOR UK ONLY

As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored green and yellow must be connected to the terminal which is marked by the letter E, or by the earth symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected to the terminal which is marked with the letter L or the color red.

(5) CIRCUIT BREAKER

The power circuit breaker serves to protect the amplifier. The trip current value has been carefully chosen to allow continuous operation at the rated power while still offering adequate

protection. Under normal conditions, the breaker will not trip unless there is a fault condition that draws excessive mains current. Please note, however, that abnormal conditions such as a short circuit applied to an output or continuous operation at overload or clipping will also cause the breaker to trip. If you suspect that the breaker has tripped because of abnormal conditions, be sure to remedy the cause of the fault before resetting the breaker. When tripped, the breaker button extends outward nearly 1/2", and can be reset by pushing inward after a brief wait to allow the breaker to cool down. When not tripped, the breaker button extends outward about 1/4". If the

5