Onkyo TXSR307 instruction manual Error Messages, To Retry the Room Correction and Speaker Setup

First Time Setup—Continued

5	When the following display appears,
	move the speaker setup microphone to
	measurement point c (page 33), and
	then press [ENTER].

Audyssey 2EQ™ performs more measurements.

This takes a few minutes.

When the measurements are complete, the results are calculated and saved automatically.

6	When the room correction and speaker
	setup is complete, disconnect the
	speaker setup microphone.

Note:

When the room correction and speaker setup is complete, “6. Equalizer” (page 56) will be set to “Audyssey.”

Error Messages

While the room correction and speaker setup is in progress, one of the following error messages may appear:

❏Ambient noise is too high

This message appears if there’s too much background noise and the measurements cannot be performed properly. Remove the source of the noise and try again.

❏Speaker Detect Errors

This message appears if one of the speaker-related errors below occurs.

•One of the front speakers has not been detected.

•One of the surround speakers has not been detected.

❏Write Error

This message appears if saving fails.

❏Mismatch Error

This message appears if a speaker that was detected during the 1st measurement is not detected during the 2nd or 3rd measurements. If this message appears, check your speaker connections, and then try again.

To Retry the Room Correction and Speaker Setup

Press the [ENTER] button.

Make sure speakers that cannot be detected are connected properly.

Changing the Speaker Settings Manually

If you wish to make changes to the settings found during the room correction and speaker setup, follow the directions on pages 54–56.

Using a Powered Subwoofer

If you’re using a powered subwoofer, as it outputs very low-frequency sound and its position is usually low down, it may not be detected by the Audyssey 2EQ Room Correction and Speaker Setup. In this case, increase the subwoofer’s volume, select its highest crossover frequency, and then try running the Audyssey 2EQ Room Correction and Speaker Setup again. Note that if the volume is set too high and the sound distorts, it may not be detected, so use an appropriate volume level. If the subwoofer has a low- pass filter switch, set it to Off or Direct. Refer to your subwoofer’s instruction manual for details.

35