Controlling Other Components
You can control your DVD player, CD player, and other components with the AV receiver’s remote controller. To control another component, you must first enter that component’s remote control code to a REMOTE MODE button.
1 | See page 63 for the Onkyo |
| |
| component’s remote control |
| code. |
This section explains how to enter remote control codes and how to control your other components.
Preprogrammed Remote Control Codes
The following REMOTE MODE buttons are preprogrammed with remote control codes for controlling the components listed. You do not need to enter a remote control code to control these components. For details on controlling these components, see the pages indicated.
Onkyo DVD/BD player (page 64)
Onkyo CD player (page 65)
Onkyo RI Dock with u(page 66)
Entering Remote Control Codes
You’ll need to enter a code for each component that you want to control.
2
(3 seconds)
While holding down the REMOTE MODE button to which you want to enter a code, press and hold down the [DISPLAY] button until the Remote indicator lights up (about 3 seconds).
Notes:
•Remote control codes cannot be entered for the [RECEIVER] buttons.
•Apart from the [RECEIVER] button, remote control codes from any category can be entered for the REMOTE MODE buttons. However, these buttons also work as input selector buttons (page 38), so choose a REMOTE MODE button that corresponds with the input to which you connect your component. For example, if you connect your CD player to the CD input, choose the [CD] button when entering its remote control code.
Remote
indicator | DISPLAY |
REMOTE 
3 | Within 30 seconds, use the | |
number buttons to enter the 5- | ||
| ||
| digit remote control code. |
MODE
AUDIO
Number buttons
RECEIVER
The Remote indicator flashes twice. |
If the remote control code is not entered |
successfully, the Remote indicator will |
flash once slowly. |
Note:
The remote control codes provided are correct at the time of printing but subject to change.
62
