First Time
2 | Use the Up and Down [q]/[w] |
| buttons to select “2.Digital |
Audio”, and then press [ENTER].
3 | Use the Up and Down [q]/[w] | |
| buttons to select an input | |
| selector, and then use the Left | |
| and Right [e]/[r] buttons to | |
| select: |
|
| COAX: Select if the component is | |
|
| connected to DIGITAL IN |
|
| COAXIAL. |
| OPT1: Select if the component is | |
|
| connected to DIGITAL IN |
|
| OPTICAL 1. |
| OPT2: Select if the component is | |
|
| connected to DIGITAL IN |
|
| OPTICAL 2. |
| - - - - | Select if the component is |
|
| connected to an analog input. |
4 | Press the [SETUP] button. | |
Setup closes. | ||
|
Notes:
•Make sure you also set your digital sources to send out a digital signals. Please refer to the digital sources’ manual.
•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.
Changing the Input Display
If you connect an
This setting can only be changed on the AV receiver.
CBL/SAT TV/TAPE |
VCR/DVR |
1 | Press the [TV/TAPE], [CBL/SAT] |
| |
| or [VCR/DVR] input selector |
| button so that “TV/TAPE”, |
| “CBL/SAT” or “VCR/DVR” |
| appears on the display. |
| or |
or
2 | Press and hold down the | ||
| |||
| [TV/TAPE], [CBL/SAT] or | ||
| [VCR/DVR] input selector button | ||
| (about 3 seconds) to change the | ||
| setting. |
| |
| Repeat this step to select MD, CDR, or | ||
or | DOCK. |
|
|
| For the TV/TAPE input selector, the | ||
| setting changes in this order: | ||
| TV/TAPE → MD → CDR | ||
or | → | DOCK | → |
| |||
|
|
For the CBL/SAT input selector, the setting changes in this order:
CBL/SAT ↔ DOCK
For the VCR/DVR input selector, the setting changes in this order:
VCR/DVR ↔ DOCK
Note:
DOCK can be selected for the TV/TAPE or CBL/SAT or VCR/DVR input selector, but not at the same time.
37