Dukane 8767 Selecting a Source, Adjusting the Picture Size and Position, Adjust the Tilt Foot

Selecting a Source

Selecting the computer or video source

Using the Remote Control

OFF			ON
		POWER
VIDEO			AUTO ADJ.
S-VIDEO RGB
		MENU
		SELECT		Press any one of the RGB, VIDEO or
				S-VIDEO buttons.
N			L
E			CE
T
E	R	N
		CA

PJ

PICTURE ASPECT

HELP FREEZE PIC-MUTE

MAGNIFY

VOLUME

Adjusting the Picture Size and Position

Place your projector on a flat level surface and ensure that the projector is square to the screen.

Lift the front edge of the projector to center the image vertically.

*If the projected image does not appear square to the screen then use the Keystone feature for proper adjustment. See page E-19.

Move the projector left to center the image horizontally on the screen.

Using the cabinet buttons

Press any one of the RGB,

VIDEO or S-VIDEO buttons.

NOTE: If no input signal is available, the projector will display a blue background (factory preset).

Adjust the Tilt Foot

1. Lift the front edge of the projector.

Adjustable Tilt Foot Lever

Adjustable Tilt Foot Lever

Adjustable Tilt Foot

2. Push up the Adjustable Tilt Foot Levers on the right and left sides of the projector to extend the adjustable tilt feet (maximum height).

3. Push down the Adjustable Tilt Foot Levers.

4. Lower the front of the projector to the desired height (max. 40mm/ 1.6”) and release the Adjustable Tilt Foot Lever to lock the Adjust- able tilt foot. There is approximately 10 degrees of up and down ad- justment for the front of the projector.

E-18