SETTING
E
Power management
This function turns Projection Lamp off when this projector detects signal interruption and is not used for a certain period in order to reduce power consumption and maintain
Power Management function operates to turn Projection Lamp off when input signal is interrupted and any button is not pressed over 5 minutes. This function operates as follows;
1.When any input signal is interrupted, “No signal” and counting down display appears (for 5 minutes).
2.After counting down for 5 minutes, projector lamp and READY indicator are turned off.
3.When READY indicator flashing, Projection Lamp can be turned on again (Power Management mode).
In this Power Management mode, Projection Lamp is automatically turned on when input signal connected or projector is operated with any button on Top Control or on Remote Control Unit again.
On start
When this function is “On,” projector is automatically turned on just by switching MAIN ON/OFF SWITCH on.
Note ; Be sure to turn projector off properly (refer to section “TURNING OFF PROJECTOR” on P21). If projector is turned off in wrong steps, On Start function does not operate properly.
Time left until Lamp off.
Press SELECT button at this icon to display other items.
On start
Press SELECT button at this icon to display previous items.
Move pointer to item and then press
POINT LEFT/RIGHT button(s).
Lamp Mode
This Projector is equipped with 2 Projection Lamps and a number of using lamps can be switched to 2 lamps or 1 lamp. Using 1 lamp maintain life of Projection Lamps.
To change over Lamp Mode
1.Press MENU button and
2.Press POINT DOWN button to move a red frame pointer to “Lamp mode”. Set "2 lamps mode" or "1 lamp mode" by pressing POINT LEFT/RIGHT button(s). When Lamp Mode is set from "2 lamps mode" to "1 lamp mode" image becomes little darker. When Lamp Mode is set from "1 lamp mode" to "2 lamps mode" image become brighter gradually.
NOTE : After changing Lamp Mode, it cannot be switched again for 90 seconds.
Remote control
This projector has two different remote control codes;
When operating projector in “Code 2,” both projector and Remote Control Unit must be switched to “Code 2.”
To change code of Projector;
Set Remote control in SETTING MENU to “Code 2.”
To change code of Remote Control Unit;
Press both MENU and IMAGE buttons on Remote Control Unit together for over 10 seconds.
After changing code, make sure Remote Control operates properly.
To return to normal code (Code 1), operate both projector and Remote Control in ways above again.
NOTE : When batteries of Remote Control Unit are replaced or
40