Dukane 28A8800A Basic operations, To project, Turn on the main power switch of the projector I on

Basic operations

To project

1

2

5 7 4 2

5

3

VIDEO RGB

LASER

STANDBY/ON POSITION

RESET

MENU

FREEZE

MAGNIFY VOLUME

OFF

P in P MUTE

BLANK AUTO TIMER

FOCUSZOOM

7

4

1		Turn on the main power switch of the projector [ I: ON].
		• The Power indicator lights orange.
2		Press the STANDBY / ON button.
		• The Power indicator will blink green and then light green.
		• The green blinking indicates warmup.
		• After the power is turned on, the lamp will be cooled for approximately 1 min. and the power cannot
		be turned on even by pressing the STANDBY/ON button.
	3	Remove the lens cap.
4		Use the ZOOM button to adjust the screen size.
5		Use the FOCUS button to adjust the focus.
		(1) The display shown to the right will appear when the FOCUS button is pressed.	+++FOCUS+++
		(2) Use the FOCUS button to adjust the focus until the image is sharp.
		(3) The message “Focus” will disappear if any other button is pressed.
		• (When there is no input signal, the Focus characters are not displayed when the input signal is outside the sync range.)
6		Turn on the power to the connected equipment.
		Refer to page 31 concerning the connection of other equipment.

7 Press either the INPUT button of the projector or the VIDEO/RGB button of the remote control to select the signal to be projected on the screen.

Example on-screen display

RGB 1

The selected signal input channel will be displayed in the lower right part of the screen.

13