Dukane 28A8800A manual Turning off the power, Plug & Play, Attach the lens cap

Page 16

Basic operations (continued)

Turning off the power

1

1

VIDEO RGB

LASER

STANDBY/ON POSITION

			RESET
		MENU
	2		FREEZE
	2	MAGNIFY	VOLUME
		MAGNIFY	VOLUME
	3		OFF
	3	P in P	MUTE
		P in P	MUTE
		BLANK	AUTO TIMER

1	Press the STANDBY/ON button for approximately 1 sec.
1	• The Power indicator will blink orange, then the lamp will turn off. Approximately 1 sec. after that, the
	lamp will light orange.
	• After the power is turned off, the lamp will be cooled for approximately 1 min. and the power cannot
	be turned off even by pressing the STANDBY/ON button.
	• The standby status will not be entered if the time which the STANDBY/ON button is pressed is too
	short.

2	Turn off the main power switch of the projector [ : OFF].
3	Attach the lens cap.

Caution The fan will continue running for approximately 1 min. after the STANDBY/ON button is pressed. Do not turn off the main power switch while the lamp is on because this will shorten the service life of the lamp.

Plug & Play

This projector is VESA DDC 1/2B compatible. Plug & play is possible by connecting to a computer that is VESA DDC (Display Data Channel) compatible.

(Plug & play is a system configured with peripheral equipment including a computer and display, and an operating system.

Caution Use the RGB cable included with this projector when using plug & play. With other cables, pins (12) - (15) are sometimes not connected (effective only for RGB).

14

Image 16

Contents Liquid Crystal Projector Page Contents FeaturesOutline Page Before Use If a problem should occur Do not install on an unstable surfaceDo not look through the lens when the lamp is on Use only the indicated power supplyDo not position the power Handle the power cord with careDo not allow the laser beam to enter the eyes Care and maintenance Battery usageClean the projector interior once every two years Avoid installation in humid or dusty locationsSound volume Avoid excessively hot locationsLens care Cabinet careChecking the package Contents Names and functions of each partNames and functions of each part Remote control transmitter Names and functions of each partClose the battery cover Remove the battery CoverLoading the batteries Installation Typical LCD Projector and Screen InstallationUsing the adjusters Top view Side viewTurn on the main power switch of the projector I on Turn on the power to the connected equipmentBasic operations To projectTurning off the power Turn off the main power switch of the projector OFFPlug & Play Press the STANDBY/ON button for approximately 1 secFreeze function Cancelling the Freeze functionPress the Freeze button Magnify function Changing the magnification ratioMoving the display area Returning to normal displayAdjustments and functions Returning to the initial settingsSET UP Using the Setup MenuInput Image OPT Connection to the video signal terminals Connection to the RGB signal terminalInput signals Signal input jacksConnection to the RGB signal terminal Example of computer signalConnection to the RGB signal terminal Initial set signalsConnecting the USB Connection to the control signal terminal Mouse functionsConnection to the control signal terminal Control signal jackRS232C communication Command data chart System VideoRequesting projector status Cleaning the Air filter Example of system setupPull out the power cord Remove the front air filter Cleaning the air filter with a vacuum cleaner Installing the air filterLamp Message tableWhen you think something wrong IndicatorsDimensional Diagram Legal Information Audio Visual Products