Dukane 8044 manual Connecting Power Supply, Firmly plug the power cord’s plug 1 into the outlet

Page 11

Setting Up (continued)

Connecting Power Supply

WARNING • Please use extra caution when connecting the power cord as incorrect or faulty connections may result in FIRE and/or ELECTRICAL SHOCK. Please adhere to the “User’s manual – Safety Guide” and the following.

•Only plug the power cord into outlets rated for use with the power cord’s specified voltage range.

•Only use the power cord that came with the projector. If it is damaged, contact your dealer to newly get correct one.

•Never modify the power cord. Never attempt to defeat the ground connection of the three-pronged plug.

•Make sure that you firmly connect the power cord to the projector and wall outlet.

1 Connect the connector of the power cord to the AC inlet of the projector. 1

AC Inlet Connector Side

2 Firmly plug the power cord’s plug 1 into the outlet.

Image 11

Contents Model Contents Preparation Projector FeaturesFastening The Lens Cap Part NamesProjector Input button Power indicator Temp indicatorRemote Control Arrangement Setting UpTwisting the elevator feet by hand Adjusting The Projectors ElevatorAdjust the height of the projector by As necessary, you can also finelyConnecting Your Devices AUDIO-R Scart AUDIO-LFirmly plug the power cord’s plug 1 into the outlet Connecting Power SupplyPutting Batteries Remote ControlRemove Battery cover Close Battery coverOperating The Remote Control Set the power switch to on Power ON/OFFTurning On The Power When the lens cap is attached, removeSelecting An Input Signal Attached the lens cap Turning Off The PowerSwitch the power switch to O OFF Temporarily Muting The Sound Adjusting The VolumeOperating Press the Position button Adjusting The PositionUse Buttons to adjust Position Correcting Keystone Distortions Using The Automatic Adjustment FeaturePress the Magnify on button Using The Magnify FeatureUse Buttons to adjust the zoom Level Freezing The ScreenTemporarily Blanking The Screen Signal SearchingSelecting The Aspect Ratio Using The Menu Functions Multifunctional SettingsMain Menu Picture 1 Menu MY Memory Load/Save a SettingReset the PICTURE-1 Menu Items Picture 1 MenuSize PhasePicture 2 Menu Position3D-YCS Input MenuVideo Frame LockS2-ASPECT Input MenuVideo NR InformationSearch AdjustAuto Menu Message Screen MenuStart UP Lamp Time Option MenuScreen Type Lamp Replacing The Lamp Caring For The Air Filter Air FilterFilter, while pulling down it Replacing The Air FilterNew air filter. Tell the dealer your air Hold the release buttons of the airCaring For The Lens Caring For The Cabinet And Remote ControlOther Care Caring For The Inside Of The ProjectorRelated Messages TroubleshootingRelated Messages Power Lamp Temp Regarding The Indicator LampsIndicator Regarding The Indicator LampsPhenomena That May Easily Be Mistaken For Machine Defects Phenomena That May Easily Be Mistaken For Machine Defects Warranty And After-ServiceVideo Input Ports SpecificationsSpecification RGB Input Ports Audio PortsPage Projector ModelTechnical Signal ConnectorsVesa Example Of Computer SignalResolution FH kHz FV Hz Rating Signal mode Display Vesa TextMac 13mode Initial Set SignalsRS-232C Communication Connecting The CableCommunications Setting Increasing the projector setting value Increment command Requesting projector status Get commandChanging the projector settings Set command Using the projector default settings Reset Command4A D2 Command Data Chart日本語 Be EF EF F6 Be EF EC D9 Auto RGB Middle Be EF High Mute Turn OFF Be EF Page Audio Visual Products