14 | Appendix |
Compliance
Declaration of Conformity
In accordance with ISO/IEC Guide and EN 45014:
Manufacturer’s Name | ClearOne Communications, Inc. |
Manufacturer’s Address | 1825 Research Way |
| Salt Lake City, UT 84119 |
Declares that Product | Scan Converter |
Conforms to the following product specifications
–Safety International: IEC 950:1991
–Europe: EN 60950: 1992
This product complies with the requirements of the Low Voltage Directive 72/23/EEC.
EMC CISPR22: 1985/EN55022: 1995 Class B
EN 55022 | Class B: 1998 |
EN | 1995 |
EN | 1995 |
EN 55024 | 1998 |
CFR 47 | 1999 §15.107 and §15.109 Class B |
This product complies with the requirements of the EMC Directive 89/336/EEC.
According to CFR 47:1999, Sections 15.107 and 15.109 – Class B
This device complies with Part 15 of the FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Appendix | 15 |
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residen- tial installation.This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter- ference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio or TV technician for help.
Supplied cables must be used with this unit to ensure compliance with the Class B FCC Limits.
Also a Class B digital device meets all requirements of the Canadian Interference- Causing Equipment Regulations.
Technical Services Group ~ | Technical Services Group ~ |