CH Tech M222 user manual Preparation for Reshipment

Page 12

2.4 PREPARATION FOR RESHIPMENT

If the module is to be shipped separately it should be enclosed in a suitable water and vapor proof anti-static bag. Heat seal or tape the bag to insure a moisture-proof closure. When sealing the bag, keep trapped air volume to a minimum. The shipping container should be a rigid box of sufficient size and strength to protect the equipment from damage. If the module was received separately from a C&H system, then the original module shipping container and packing material may be re-used if it is still in good condition.

C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com

Image 12

Contents D E L Copyright Copyright 2007 by C&H Technologies, IncAmendment Notice Introduction Table of Contents List of Figures List of TablesGeneral Description Maximum Ratings DMA Page Installation Module InstallationPreparation for Reshipment Switching Schematic Functional DescriptionTable II. I/O Address Map/Command Summary Offset Hex Register Name Register TypeStatus ControlInterrupt RelayTable III. M/MA Module Prom Ident Words VXI IDOperation Effects of Opening/Closing RelayPage Appendix a Connectors Figure A-1. Front Panel I/O SignalsPage T E S Page Readers Comment Form CommentsInstructions