CH Tech M222 Table II. I/O Address Map/Command Summary, Offset Hex Register Name Register Type

Page 14

C&H Technologies, Inc. <> 445 Round Rock West Drive <> Round Rock, TX 78681 <> www.chtech.com

3.2 IDENTIFICATION AND CONFIGURATION REGISTERS

3.2.1 I/O Registers

There are a variety of registers used to configure and control the M222 module. These registers are located in the IOSpace. The address map of the registers is shown in Table II. Details of the registers are provided in Figure 3.

Table II. I/O Address Map/Command Summary

Offset

 

 

(hex)

Register Name

Register Type

00

Status Register

Read Only

02

Control Register

Read/Write

04

Interrupt

Read Only

06 – 12

Reserved

NA

14

Relay

Read/Write

16 – FC

Reserved

NA

FE

ID EEPROM

Read/Write

8

Image 14
Contents D E L Copyright Copyright 2007 by C&H Technologies, IncAmendment Notice Introduction Table of Contents List of Figures List of TablesGeneral Description Maximum Ratings DMA Page Installation Module InstallationPreparation for Reshipment Switching Schematic Functional DescriptionTable II. I/O Address Map/Command Summary Offset Hex Register Name Register TypeInterrupt StatusControl RelayTable III. M/MA Module Prom Ident Words VXI IDOperation Effects of Opening/Closing RelayPage Appendix a Connectors Figure A-1. Front Panel I/O SignalsPage T E S Page Readers Comment Form CommentsInstructions