Dell M109S manual Appendix Glossary

Page 29

Appendix: Glossary

ANSI Lumens—A standard for measuring the brightness. It is calculated by dividing a square meter image into nine equal rectangles, measuring the lux (or brightness) reading at the center of each rectangle, and averaging these nine points.

Aspect Ratio—The most popular aspect ratio is 4:3 (4 by 3). Early television and computer video formats are in a 4:3 aspect ratio, which means that the width of the image is 4/3 times the height.

Brightness—The amount of light emitting from a display or projection display or projection device. The brightness of projector is measured by ANSI lumens.

Color Temperature— The color appearance of white light. Low color temperature implies warmer (more yellow/red) light while high color temperature implies a colder (more blue) light. The standard unit for color temperature is Kelvin (K).

Component Video—A method of delivering quality video in a format that contains all the components of the original image. These components are referred to as luma and chroma and are defined as Y'Pb'Pr' for analog component and Y'Cb'Cr' for digital component. Component video is available on DVD players and projectors.

Composite Video—A video signal that combines the luma (brightness), chroma (color), burst (color reference), and sync (horizontal and vertical synchronizing signals) into a signal waveform carried on a single wire pair. There are three kind of formats, namely, NTSC, PAL and SECAM.

Compressed Resolution—If the input images are of higher resolution than the native resolution of the projector, the resulting image will be scaled to fit the native resolution of the projector. The nature of compression in a digital device means that some image content is lost.

Contrast Ratio—Range of light and dark values in a picture, or the ratio between their maximum and minimum values. There are two methods used by the projection industry to measure the ratio:

1 Full On/Off — measures the ratio of the light output of an all white image (full on) and the light output of an all black (full off) image.

2 ANSI — measures a pattern of 16 alternating black and white rectangles. The average light output from the white rectangles is divided by the average light output of the black rectangles to determine the ANSI contrast ratio.

Full On/Off contrast is always a larger number than ANSI contrast for the same projector.

Glossary

29

Image 29
Contents Dell M109S Projector Page Contents Troubleshooting Your Projector Your Dell Projector Package ContentsAbout Your Projector Connecting Your Projector Connecting a Computer Connecting a DVD Player using a Composite Cable Connecting a DVD PlayerConnecting Your Projector Turning Your Projector Off Using Your ProjectorTurning Your Projector On Adjusting the Projector Focus Projector to screen distance Adjusting Projection Image SizeUsing the Control Panel OSD AUTO-ADJUST Using the On-Screen DisplayPicture in PC Mode Using Your Projector Display in PC Mode SET UP Using Your Projector Others Problem Troubleshooting Your ProjectorProblem Possible Solution Specifications Compatibility Modes Analog Visit support.dell.com Contacting DellContacting Dell Glossary Appendix GlossaryGlossary Glossary Glossary Others IndexTroubleshooting, 23 contact Dell