Dell M109S manual Display in PC Mode

DISPLAY (in PC Mode)

Using the Display menu, you can adjust the display settings of your projectors. The Display menu provides the following options:

ASPECT RATIO—Allows you to set the aspect ratio.

• 4:3 - The input source scales to fit the screen.

• Original - The input source scales to fit the screen while keeping the aspect ratio of the input source.

• Wide - The input source scales to fit the width of the screen.

Use Wide or 4:3 if you are using one of the following:

-Computer resolution greater than SVGA

-Component cable (720p/1080i/1080p)

DIGITAL ZOOM—Press to digitally magnify an image up to 4 times on the projection screen and press to reduce the zoomed image.

ZOOM NAVIGATION—Press to navigate projection screen.

HORIZONTAL POSITION—Press to move the image to the right and to move the image to the left.

VERTICAL POSITION—Press to move the image down and to move the image up.

FREQUENCY—Allows you to change the display data clock frequency to match the frequency of your computer graphics card. If you see a vertical flickering wave, use Frequency control to minimize the bars. This is a coarse adjustment.

TRACKING—Synchronize the phase of the display signal with the graphic card. If you experience an unstable or flickering image, use Tracking to correct it. This is a fine adjustment.

DISPLAY (in Video Mode)

Using the Display menu, you can adjust the display settings of your projectors. The

Using Your Projector

19