6.0 Tests Performed
The following tests are performed at room temperature (+25 ℃).
6.1Input Characteristics
Input Voltage Range.
6.2Output Characteristics
Line Regulation. Load Regulation. Output Regulation.
Output Voltage
Output Voltage Tracking
6.3Dynamic Characteristics
Maximum Output Voltage Deviation (due to step change in load).
Turn on Response time.
6.4Thermal Characteristic Efficiency
7.0Test Set-Up
7.1Initial Set-Up
1)Examine the part number of the power module to determine that the correct module is being evaluated. Note: DNM04S0A0S10P A would denote the SMT package, while DNM04S0A0R10P A would denote the SIP package. This Evaluation Board is for use with SMT package.
2)Set the
3)Electronic Load
Turn on the Electronic Load at CR mode (or resistive load) and adjust the current level. The maximum rated output current is 10A for the model DNM series and 16A for the DNL series. Ensure the output load does not exceed the recommended maximum current.
4)SW1 is used for on/off Transient function test. Turn SW1 to the OFF position if this function is not being used. Turn SW1 to the ON position if the Transient function test is required.
4