Delta Electronics DNL Series manual PS1=5V PS2=3.3V, Simultaneous Implementation

Page 14

For example, the PS1 Voset,PS1=5V, the PS2 Voset,PS2=3.3V, R1 is calculated as follows:

R1 =

[(3.3 − 1.3) − 1.32]

* 20K = 10.303K Ω

1.32

 

 

PS1=5V

PS2=3.3V

-△V=1.3V

PS1

PS2

Figure 9. Ratio–metric tracking Power up

Figure 10. Ratio–metric tracking Power down

Simultaneous Implementation

Similar to the ratio-metric implementation, simultaneous tracking is implemented using a voltage divider on the TRACK pin. The objective is to minimize the voltage difference between the power supply outputs during power up and down. The waveforms of power up and down are showed in Figures 13 and 14.

For type A (DNXXX0A0XXXX A), the simultaneous tracking can be accomplished by connecting VoPS1 to the TRACK pin of PS2. Figure 11 shows the circuit diagram of voltage Simultaneous start-up when VoPS2 tracks VoPS1(only for type A).

Vin

PS1PS2

Vin

VoPS1

VoPS2

TRACK

ENABLE

ENABLE

Figure 11. PS1 and PS2 track output voltage Simultaneous start-up for type A

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Relevant Documentation Delphi DNM and DNL Series of SMT type POL convertersPurpose Equipment Required Equipment Set-Up and DescriptionThermal Management of the Converter Tests Performed Test Set-UpInitial Power Up SW3 Function tableNo Load Input Current Test Tests and EvaluationTest Output Ripple Output Characteristics Line RegulationLoad Regulation 10500 For DNM04xx and DNL04xx series Vtrim = 0.7 − 0.1698 ⋅ Vout −For DNM12xx and DNL12xx series Voltage MarginingVoltage Tracking Detailed Description Sequential ImplementationPS1 PS2 Ratio-Metric ImplementationVref PS1=5VPS1=5V PS2=3.3V Simultaneous ImplementationVref define Dynamic Characteristics Output Voltage Deviation TestTurn-On Response Time Test Turn on the module by using the external switchTest Turn on the module by using the Enable on/off Thermal Characteristic Efficiency Appendix A- Evaluation Board Schematic Warranty
Top Page Image Contents