Delta Electronics GBIC-1250A5FR specifications Gbic module definition parameters

GBIC-1250A5FR

GBIC module definition parameters

Module	MOD_DEF(0)	MOD_DEF(1)	MOD_DEF(2)	Interpretation by host Reference
Definition	Pin 4	Pin 5	Pin 6
0	NC	NC	NC	GBIC not present clause
				Copper Style 1 or Style 2 connector, 1.0625 Gbd,
1	NC	NC	TTL LOW	100-TW-EL-S or 100-TP-EL-S, active
				inter-enclosure connection and IEEE802.3
				1000BASE-CX
				Copper Style 1 or Style 2 connector, 1.0625 Gbd,
2	NC	TTL LOW	NC	100-TW-EL-S, or 100-TP-EL-S, active or passive
				intra-enclosure connection
3	NC	TTL LOW	TTL LOW	Optical LW, 1.0625 Gbd 100-SM-LC-L
4	TTL LOW	SCL	SDA	Serial module definition protocol
5	TTL LOW	NC	TTL LOW	Optical SW, 1.0625 Gbd 100-M5-SN-I or
				100-M6-SN-I
				Optical LW, 1.0625 Gbd 100-SM-LC-L and similar
6	TTL LOW	TTL LOW	NC	to 1.25 Gbd IEEE802.3z 1000BASE-LX, single
				mode
				Optical SW, 1.0625 Gbd 100-M5-SN-I or
7	TTL LOW	TTL LOW	TTL LOW	100-M6-SN-I and 1.25 Gbd, IEEE 802.3z,
				1000BASE-SX

GBIC timing parameters for GBIC management

Parameter	Symbol	Min.	Max.	Unit	Unit Conditions
TX_DISABLE assert time	t_off		10	μsec	Rising edge of TX_DISABLE to fall of output signal
					below 10% of nominal
TX_DISABLE negate	t_on		1	mec	Falling edge of TX_DISABLE to rise of output
time					signal above 90% of nominal
Time to initialize,					From power on or hot plug fter V DD T > 4.75 volts
includes reset of	t_init		300	msec	or From negation of TX_DISABLE during reset of
TX_FAULT					TX_FAULT.
TX_FAULT from fault to	t_fault		100	μsec	From occurrence of fault (out-put safety violation or
assertion					V DD T < 4.5 volts)
TX_DISABLE time to	t_rest	10		μsec	TX_DISABLE HIGH before TX_DISABLE set LOW
start reset
RX_LOS assert delay	t_loss_on		100	μsec	From detection of loss of signal to assertion of
					RX_LOS
RX_LOS negate delay	t_loss_off		100	μsec	From detection of presence of signal to negation of
					RX_LOS
				6	2008/1/23
					Rev. 0A
DELTA ELECTRONICS, INC.					www.deltaww.com