Delta Electronics Series DNS manual Electrical Characteristics Curves

Page 6

ELECTRICAL CHARACTERISTICS CURVES

Figure 19: Typical transient response to step load change at 2.5A/μS from 100% to 50% of Io, max at 5Vin, 3.3Vout (Cout = 1uF ceramic, 10μF tantalum)

Figure 20: Typical transient response to step load change at 2.5A/μS from 50% to 100% of Io, max at 5Vin, 3.3Vout (Cout =1uF ceramic, 10μF tantalum)

Figure 21: Typical transient response to step load change at 2.5A/μS from 100% to 50% of Io, max at 5Vin, 1.8Vout (Cout =1uF ceramic, 10μF tantalum)

Figure 22: Typical transient response to step load change at 2.5A/μS from 50% to 100% of Io, max at 5Vin, 1.8Vout (Cout = 1uF ceramic, 10μF tantalum)

DS_DNS04SIP06A_07172008

6

Image 6

Contents Delphi DNS, Non-Isolated Point of Load Technical Specifications Parameter DNS04S0A0R06PFDElectrical Characteristics Curves Converter efficiency vs. output current 3.3V outElectrical Characteristics Curves CON Output ripple & noise at 3.3Vin, 2.5V/6A outTurn on delay time at 5Vin, 3.3V/6A out Electrical Characteristics Curves Output short circuit current 5Vin, 0.75Vout Test Configurations Design ConsiderationsInput Source Impedance Design Considerations CON Features DescriptionsSafety Considerations Remote On/OffRemote Sense Features Descriptions CONOver-Temperature Protection Output Voltage ProgrammingFeature Descriptions CON Voltage MarginingVoltage Tracking Sequential Start-up Ratio-MetricThermal Testing Setup Thermal Curves Thermal ConsiderationsThermal Derating Ambient temperature and air velocity@Vin=3.3V, Vo=2.5V Mechanical Drawing Part Numbering System Model List