Compaq PC-CARD Connecting the board for I/O operations, Connectors, cables main I/O connector

PC-CARD-DIO48 User's Guide Installing the PC-CARD-DIO48

2.Select the Hardware tab and click on the Device Manager button.

3.Verify that "PCMCIA adapters" is listed in the Device Manager. If you don’t find this entry, or if the properties for the adapter indicate "this device is not working," you need to install or update your PCMCIA adapter drivers.

o If the PCMCIA adapter is not listed, use the Add New Hardware Wizard to install PCMCIA support.

o If the PCMCIA adapter is listed but not working, use the Update Driver option to install the appropriate drivers.

After performing the update procedure, reboot your PC and insert your card again.

Connecting the board for I/O operations

Connectors, cables – main I/O connector

The table below lists the board connector, applicable cables, and compatible accessory products.

	Board connector, cables, and accessory equipment
Connector type		50-pin connector
Compatible cables		CPCC-50F-39: 50-pin Micro connector to 50-pin female IDC, one-meter cable
		(39 inches).
		ƒ CPCC-50M-4: 50-pin Micro connector to 50-pin male IDC, 4 inch adapter cable.
		and
		ƒ C50FF-x: 50-pin IDC female to female cable. x = length in feet.
Compatible accessory products		CIO-MINI50
		CIO-SPADE50
		CIO-TERM100
		SCB-50
		SSR-RACK24
		CIO-ERB24
		CIO-ERB48
		CIO-SERB24
		CIO-SERB48

Pin out – main I/O connector

Figure 3 shows a PC-CARD-DIO48 case looking into the male mini-connector. The connector is mechanically keyed to insure that the cable is inserted correctly.

Figure 3. 50-pin I/O mini-connector

11