Compaq 99875320-5 manual Decodeenable Property

Page 30

USB HID IntelliHead Swipe Reader

DECODE_ENABLE PROPERTY

Property ID:

0x1A

Property Type:

Byte

Length:

1 byte

Get Property:

Yes

Set Property:

Yes

Default Value:

0x00

Description:

This property is defined as follows:

Bit

7

6

5

4

3

2

1

0

Position

Decode

Reserved

Reserved

Reserved

Reserved

Reserved

Reserved

Reserved

JIS Type 2

Type

When a decode type bit is set to 1 (true), the decode type represented by that bit is enabled. When a decode type bit is set to 0 (false), the decode type represented by that bit is disabled. The reserved decode type bits should always be set to zero.

This property is stored in non-volatile memory, so it will persist when the unit is power cycled. When this property is changed, the unit must be reset (see Command Number 2) or power cycled to have these changes take effect.

Note

The JIS type 2 decoding option was not added until firmware with software ID 21042812K01 was release in October 2008.

Example Set property Request (Hex):

Cmd Num	Data Len	Prp ID	Prp Value
01	02	1A	01 (enable JIS Type 2
			decode type)

Example Set property Response (Hex):

Result Code	Data Len	Data
00	00

Example Get property Request (Hex):

Cmd Num	Data Len	Prp ID
00	01	1A

Example Get property Response (Hex):

Result Code	Data Len	Prp Value
00	01	01

22

Image 30

Contents USB HID Intellihead October Registered to ISOPage Revisions Rev Number DateLimited Warranty Limitation on LiabilityFCC Warning Statement FCC Compliance Statement Table of Contents Vii USB IntelliHead 3-Track Features and Specifications FeaturesReference Documents Hardware ConfigurationsAccessories USB HID IntelliHead Swipe ReaderSpecifications Features and SpecificationsUSB HID IntelliHead Swipe Reader Pin Number Signal Cable Color InstallationWindows Plug and Play Setup USB ConnectionUSB HID IntelliHead Swipe Reader Operation Card ReadUSB HID IntelliHead Swipe Reader USB Communications HID UsagesReport Type Report DescriptorUsage ID Usage Name Hex Type ValueUSB Communications Value Hex Card DataTrack 1 Decode Status Offset Usage NameTrack 1 Data Length Track 2 Decode StatusTrack 3 Decode Status Track 2 Data LengthTrack 1 Data Card Encode TypeTrack Data Track 2 DataData Length CommandsCommand Number DataGET and SET Property Commands Result CodeProperty Type Description Softwareid PropertyValue Property ID Description Hex Cmd Num Data Len Prp IDResult Code Data Len Serialnum PropertyCmd Num Data Len Prp ID Prp Value 31 32 Result Code Data Len Prp Value 31 32Pollinginterval Property Cmd Num Data Len Prp ID Prp ValueResult Code Data Len Prp Value Maxpacketsize Property Trackidenable Property Interfacetype Property Decodeenable Property Resetdevice Command Cmd Num Data LenUSB HID IntelliHead Swipe Reader Installation Demo ProgramOperation Source Code Appendix A. Drawings Part Number TitleUSB HID IntelliHead Swipe Reader Appendix A. Drawings USB HID IntelliHead Swipe Reader Appendix A. Drawings USB HID IntelliHead Swipe Reader Appendix A. Drawings USB HID IntelliHead Swipe Reader Appendix A. Drawings USB HID IntelliHead Swipe Reader