Compaq 5525B/31/32 manual HP PCL-II Emulation Default Settings, Switching Between the Emulations

Chapter 2 Introduction

HP PCL-II Emulation Default Settings

The factory settings for the PCL-II emulation menu options are shown in Table 1. Host control codes can override the settings for these menu options.

Table 1. PCL-II Menu Option Factory Settings

Parameter	Default Setting
Primary/Secondary Character Set
ID	0
Symbol Set	Roman-8(8U)
Pitch	10.0 cpi
Density	Data Processing
Page Length Representation	Inches/Page
Graphics Density	60 dpi
Perforation Skip	Disable
Display Functions	Disable
LF after CR	Disable
CR after LF	Enable
CR after FF	Enable
CR after VT	Enable
PTX Linefeed	Disable
LPI Adjust	6 LPI
Page L. /Lines	66 lines
Page L. /Inches	11 Inches

Switching Between the Emulations

The printer supports four emulations: PCL-II (the default), LinePrinter Plus, Code V™ and IGP ®/PGL®. The LinePrinter Plus has three protocols from which to choose: P-Series, Proprinter III XL, and Epson FX-1050.

You can switch between PCL-II and any of the LinePrinter Plus protocols by sending one of the following commands:

ESC%-00000X Switches from PCL-II to P-Series

ESC%-00001X Switches from PCL-II to Proprinter III XL

ESC%-00002X Switches from PCL-II to Epson FX-1050

SFCC};K0 Switches from any of the LinePrinter Plus emulations to PCL-II

12