Christie Digital Systems 104-017101-XX, 38-DSP104-XX Legs should fit inside the stacking mounts

Stacking Frame Installation Instructions

3. Loosen the nuts on the rear stacking legs to provide lateral movement for easier alignment with the stacking mounts on the other projector.

For upright position: Release the rear stacking legs on the top projector.

For inverted position: Release the rear stacking legs on the bottom projector.

4. Remove the safety pins from each stacking mount in order to fit the stacking legs into the stacking mounts. Refer to Figure 3.

For upright position: Remove the pins from the mounts on the bottom projector.

For inverted position: Remove the pins from the mounts on the top projector.

5.	RELEASED
	With one person positioned on each side of the projector, lift the top projector onto
	the bottom projector, aligning all three stacking points between the projectors. The
	legs should fit inside the stacking mounts.

6. Turn the adjusting wheel on each stacking mount until the hole in the top portion of the mount lines up with the hole in the stacking leg. To make alignment easier insert a screwdriver into one of the holes and use it to align the two holes.

				Control 2006
		WARNING
	Step 7 is a critical safety procedure that must be observed.
		Failure to engage the safety locks could cause the
	projectors to separate, resulting in possible injury or death.
	OFFICIALLY			Figure 3. Stacking Mount Components
7.		Document			8,
	Insert the safety pin through the holes in
	the stacking mounts and stacking l gs.
		September
	Ensure each pin is fully inserted to engage
	the safety lock and secure the projectors.
	Refer to Figure 3.
8. Before hoisting, firmly tighten the nuts on
	the two rear stacking l gs. If		the
	projectors are ready for image alignment
	keep the nuts slightly loose until
	alignment is complete.
9.	When required, repeat teps 1 to 8 for the
	third projector.

013-100342-01 (Rev.1) (08/06) 5 of 12 pages