BEFORE USE (continued)
Loading the Battery
First Loading:
In original packing, the battery is installed in the battery holder of |
| |
the remote controller with protection film (the transparent film some |
| |
of which is inside the battery holder). Pull out the protection film to | “+” side | |
load the battery. | ||
|
Replacing: |
| |
1. | See the reverse side of the remote controller. |
|
2. | Pinch the groove and pull out battery holder as the drawing right. | Pull out |
3. | Remove the worn battery. | |
4. | Install the new battery with “+” side facing. | Battery Holder |
5. | Push in and click the battery holder. | |
ENGLISH
CAUTION • Incorrect handling of the battery could result in fire or personal injury. The 
battery may explode if not handled properly. Be careful in handling the battery according to instructions of accompaning manual "SAFETY INSTRUCTIONS" and this manual.
•Use the 3V micro lithium battery type no.CR2025 only.
•When loading the battery, make sure the plus and minus terminals are correctly oriented as indicated in the remote controller.
•When you dispose the battery, you should obey the law in the relative area or country.
•Keep the battery away from children and pets.
•When not to be used for an extended period, remove the battery from the remote controller.
NOTE Replace the batteries when remote control transmitter operation becomes difficult.
Fixing the Handle
Fix the enclosed handle if you need.
1. | Raise up the handle hook, and pass one end of the |
|
| handle through the hole of handle hook. |
|
2. | Buckle the end of the handle, as the right drawing. |
|
3. | Fix the other end of the handle to the other handle | 2 |
| hook in the same way. |
|
1
CAUTION • Make sure the handle is fixed before carrying the projector with the handle. If the projector should be dropped from the handle should be off,
it could result in an injury, and continued use could result in fire or electrical shock. Do not flourish the projector with the handle.