BEFORE OPERATION
Remote Control Battery Installation
1Remove the battery compartment lid.
2 Slide the batteries into the compartment.
Note : For correct polarity (+ and - terminal), be sure the battery terminals are in contact with the pins in the compartment.
3 Replace the compartment lid.
Using the Remote Control Unit
Point the remote control toward the projector (Receiver window) when pressing the buttons. Maximum operating range for the remote control is about 16.4' (5 m) and 60° front and rear of the projector.
16.4' | 16.4' |
(5 m) | (5 m) |
60° | 60° |
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or R06 type alkaline batteries.
●Change two batteries at the same time.
●Do not use a new battery with a used battery.
●Avoid contact with water.
●Do not drop the remote control unit.
●If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
23