BOXLIGHT MP-38t manual Basic Operation, Turning ON/OFF the Projector, Direct Operation

Page 27

BASIC OPERATION

TURNING ON/OFF THE PROJECTOR

TO TURN ON THE PROJECTOR

Connect the projector to a source (Computer, VCR, Video Camera, Video Disc Player, etc.) using the appropriate terminals on the rear of the projector. (See "CONNECTING THE PROJECTOR" section on pages 11-18).

Connect the projector's AC power cord into a wall outlet and turn the MAIN ON/OFF switch (located on the rear of the projector) to the ON position. The LAMP POWER indicator will light RED, the READY indicator will light GREEN.

Press the POWER ON/OFF button on the remote control unit or on the projector to ON. The LAMP POWER indicator light will dim and the cooling fans will operate. The wait display appears on the screen and the count-down starts (30-29-28-...1). The signal from the source appears after 30 seconds.

30

CAUTION:

TO MAINTAIN THE LIFE OF THE LAMP, ONCE YOU HAVE TURNED IT ON, WAIT AT LEAST 5 MINUTES BEFORE TURNING IT OFF.

NOTE: TEMPERATURE WARNING INDICATOR flashes red, the projector will automatically turn off. Wait at least 5 minutes before turning the projector on.

If the TEMPERATURE WARNING INDICATOR continued to flash, follow the procedures below:

(1). Press POWER ON/OFF button to OFF.

(2). Check the air filter for dust accumulation.

(3). Remove dust with vacuum cleaner. (See "AIR FILTER CARE AND CLEANING" section on page 49).

(4). Press POWER ON/OFF button to ON.

If the TEMPERATURE WARNING INDICATOR still continues to flash, call Boxlight Corporation at 1-800-762-5757 or 360-779-7901.

TO TURN OFF THE PROJECTOR

Press the POWER ON/OFF button on the remote control unit or on the projector. The "Power off ?'' appears on the screen. Press again the POWER ON/OFF button to turn OFF the projector. The LAMP POWER indicator will light bright and READY indicator will turn off. After approximate 1 minute, the READY indicator will light green again and the projector may be turned on by pressing the POWER ON/OFF button. The cooling fans will operate for approximate 2 minutes after the projector is turned off. To power down completely, turn the MAIN ON/OFF switch (located on the rear of the projector) to the OFF position.

DIRECT OPERATION

MODE SELECT

Press the MODE button on the projector or the COMPUTER and VIDEO button on the remote control unit to select Computer 1, Computer 2, Video Input. The "Computer 1", "Computer 2" or "Video" display will appear on the screen for a few seconds.

MODE button

Computer 1

Computer 2

Video

COMPUTER button

Computer 1

Computer 2

VIDEO button

Video

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Boxlight MP-38t To the Owner Important Safety Instructions Table of Contents Features and Design Rear of the Projector InstallationName of Each Part of the Projector Front of the ProjectorVentilation SETTING-UP the ProjectorPositioning Room LightFeet Lock Latches Down Adjustable FeetAdjustable Feet Moving the ProjectorProjector side Female AC outlet side Male Power RequirementsTerminal of the Projector Connecting the ProjectorConnecting to the Monitor Output Terminal Connecting the ComputerConnecting AN IBM-COMPATIBLE Desktop Computer Connecting AN IBM-COMPATIBLE Laptop Computer Audio Cable Not Provided Computer Audio Input Connecting a Macintosh Desktop ComputerAdapter shipped with the PowerBook Connecting a Macintosh Powerbook ComputerConnecting to the Component Video Input Jacks Connecting the Video EquipmentConnecting to the Video Input Jack Connecting S-VHS Video Input JackVideo Equipment Connecting the Video EquipmentConnecting to the EXT. SP. Jack 3.5 mm mini stereo type Before Operation Controls and IndicatorsFront Indicators TOP Controls Front Indicators TOP ControlsPage Infrared Signal Window Laser Light Window Operation of the Remote ControlComputer Select Button Remote Control Battery Installation Direct Operation Control the ProjectorCOMPUTER/VIDEO Mode Video ModeMenu Operation Menu Point LEFT/RIGHT Select Point LEFT/RIGHT/UP/DOWN Computer ModeBasic Operation Turning ON/OFF the ProjectorDirect Operation Sound Mute Function Sound Volume AdjustmentZoom Adjustment Focus AdjustmentAuto Image Function Timer FunctionNo Show Function Freeze Picture FunctionMenu Operation Language Setting Display Sound AdjustmentLanguage Adjustment Sound Adjust DisplayVideo Mode Color System SelectColor System Display Main Menu Display Component Video System Display Video Source SelectComponent Video System Select Main Menu Display Video SourcePicture Image Adjustment Main Menu Display Image Adjust DisplayTable of Picture Image Adjustment Screen Adjust Display Picture Screen AdjustmentComputer System Select Computer ModePC Adjustment Computer System Display Current Mode Main Menu DisplayCompatible Computer Specifications Main Menu Display Auto Image Setting Darker Brighter Main Menu Display Image AdjustDecrease Increase Lighter DeeperMain Menu Display Position Setting Picture Position AdjustmentPC Adjustment OK ? 630 1056 PC Adjustment DisplayMode Free True Main Menu Display Screen AdjustBlue Back On or Off Other Function SettingRemote Control Code Change Mode 1 or Mode Lamp AGE Appendix MaintenanceTemperature Warning Indicator AIR Filter Care and CleaningOrder Replacement Lamp Lamp ReplacementCleaning the Lens TroubleshootingService Remote Control Transmitters Technical SpecificationsLimited Warranty
Top Page Image Contents