Acer Computer Monitor installation instructions Controls and Connectors Cable Connections

Page 6

CONTROLS AND CONNECTORS

CABLE CONNECTIONS

Turn off your computer before performing the procedure below.

1Plug the power cable of your monitor into a nearby outlet. Plug the other end of the power cord into the PC port.

2.Connect one end of the 15-pin VGA cable to the back of the monitor and connect the other end to the computer’s D-Sub port.

3.Turn on your monitor and computer.

1

2

Figure 2 Connecting Cables

1.Power Cable

2.Signal Cable

5

Image 6

Contents Table of Contents FCC Class B Radio Frequency Interference Statement Precautions Before YOU Operate the Monitor Features Checking the Contents of the PackageSpecial Notes on LCD Monitors Power Source Installation InstructionsPowercord Swivel BaseControls and Connectors Cable Connections Connecting Cables Power Cable Signal CableAdjusting the Viewing Angle General Instructions Operating InstructionsExternal Controls Menu / Enter Front Panel ControlHOW to Adjust a Setting Adjusting the Picture Main Sub Sub Menu Description Menu IconOSD Plug & Play DDC2B Feature Using the Right Power CordPlug and Play Technical Support FAQ BlueShut-down mode Error Message & Possible Solution Cable not Connected Input not SupportAppendix Specifications DDC/CI ON/OFF Preset Display Modes Connector PIN Assignment PIN no Description