Acer AL1715 Detaching LCD Monitor from Its Stand, Interface for Arm Applications

Page 5

Detaching LCD Monitor from Its Stand

Unscrew screws the swivel base support column and pull down the hinge to release.

Interface for Arm Applications

Before installing to mounting device, please refer to Fig.1-3.

The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-4. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997).

Connecting the Display

1.Power off your computer.

2.Connect one end of the signal cable to the LCD Monitor’s VGA port.(See Fig 1-5)

3.Connect the other end of the signal cable to the VGA port on your PC.

4.Make sure connections are secure.

Connecting the AC Power

1.Connect the power cord to the LCD Monitor.(See Fig. 1-6)

2.Connect the power cord to an AC power source.

5

Figure 1-3

Figure 1-4

Figure 1-5

Figure 1-6

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Table of Contents Canadian DOC Notice PrefaceFCC Statement Warning Important Safety Instructions Connecting the LCD Monitor and Base InstallationViewing Angle Adjustment UnpackingConnecting the AC Power Connecting the DisplayDetaching LCD Monitor from Its Stand Interface for Arm ApplicationsPower Management System Connecting the Audio Cable For AL1715 m and AL1715 bmGeneral Instructions Display ControlsFront Panel Control Power ButtonAdjusting The Picture How To Adjust a SettingSave user adjustment and OSD disappear Technical Information SpecificationsMode Power Consumption AC Input LED Color Apple MAC-480 Standard Timing TableTiming Problem Picture is unclear and unstable Troubleshooting
Top Page Image Contents