BOXLIGHT CP-11t manual Important Safety Instructions, Ground

Page 3

IMPORTANT SAFETY INSTRUCTIONS

All the safety and operating instructions should be read before the product is operated.

Read all of the instructions given here and retain them for later use. Unplug this projector from AC power supply before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for cleaning.

Do not use attachments not recommended by the manufacturer as they may cause hazards.

Do not place this projector on an unstable cart, stand, or table. The projector may fall, causing serious injury to a child or adult, and serious damage to the projector. Use only with a cart or stand recommended by the manufacturer, or sold with the projector. Wall or shelf mounting should follow the manufacturer's instructions, and should use a mounting kit approved by the manufacturers.

Do not expose this unit to rain or use near water... for

example, in a wet basement, near a swimming pool, etc...

Slots and openings in the back and bottom of the cabinet are provided for ventilation, to insure reliable operation of the equipment and to protect it from overheating.

The openings should never be covered with cloth or other materials, and the bottom opening should not be blocked by placing the projector on a bed, sofa, rug, or other similar surface. This projector should never be placed near or over a radiator or heat register.

This projector should not be placed in a built-in installation such as a book case unless proper ventilation is provided.

This projector should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supplied, consult your authorized dealer or local power company.

Do not overload wall outlets and extension cords as this can result in fire or electric shock. Do not allow anything to rest on the power cord. Do not locate this projector where the cord may be damaged by persons walking on it.

d. If the projector does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the projector to normal operation.

e. If the projector has been dropped or the cabinet has been damaged.

f. When the projector exhibits a distinct change in performance-this indicates a need for service.

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or injury to persons.

Upon completion of any service or repairs to this projector, ask the service technician to perform routine safety checks to determine that the projector is in safe operating condition.

 

This projector is equipped with a

 

grounding type AC line plug.

 

Should you be unable to insert the

 

plug into the outlet, contact your

 

electrician. Do not defeat the

GROUND

safety purpose of this grounding

type plug.

 

Follow all warnings and instructions marked on the projectors.

For added protection to the projector during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet. This will prevent damage due to lightning and power line surges.

An appliance and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.

Never push objects of any kind into this projector through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the projector.

Do not attempt to service this projector yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

Unplug this projector from wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power cord or plug is damaged or frayed.

b.If liquid has been spilled into the projector.

c.If the projector has been exposed to rain or water.

If the projector is to be built into a compartment or similarly enclosed, the minimum distances must be maintained.

Do not cover the ventilation slot on the projector.

Heat build-up can reduce the service life of your projector, and can also be dangerous.

20cm

WALL

 

PROJECTOR

PROJECTOR

 

(FRONT)

(SIDE)

50cm

50cm

50cm

3

Image 3
Contents Boxlight CP-11t To the Owner Safety PrecautionsGround Important Safety InstructionsTable of Contents Compatibility Features and DesignName of Each Part of the Projector PreparationSETTING-UP the Projector Adjustable FeetPositioning the Projector Ventilation Preparation Connecting the AC Power CordPreparation Moving the Projector Terminals of the Projector Connecting the ProjectorVideo Cable Connecting to the Video EquipmentConnecting the Projector Used cables for connectionConnecting to the Computer VGA Cable Control Cable for PS/2 PortMAC Adapter Monitor Cable MAC Adapter Not supplied Computer Monitor Control Audio OUT PortBefore Operation Operation of the Remote ControlRemote Control Batteries Installation Lamp Indicator TOP Controls and IndicatorsHOW to Operate ON-SCREEN Menu Operating ON-SCREEN MenuFlow of ON-SCREEN Menu Before Operation Menu BAR Setting MenuTurning OFF the Projector Basic OperationTurning on / OFF the Projector Turning on the ProjectorKeystone Adjustment Adjusting the ImageZoom Adjustment Focus AdjustmentBasic Operation No Show Function Sound AdjustmentSound Volume Adjustment Sound Mute AdjustmentComputer Mode Selecting Computer ModeSelecting Computer System MAC LC13 Computer Mode Compatible Computer SpecificationsFreq KHzAdjust PC AdjustmentClamp Total linesTotal dots Horizontal / VerticalContrast Normal FunctionFine sync White balance Red / Green / BluePosition Picture Position AdjustmentComputer Mode Auto Image Function Auto ImagePanning function Picture Screen AdjustmentExpand function Compress functionAuto Video ModeSelecting Video Mode Selecting Color SystemSharpness Adjusting the Picture ImageColor TintSetting Setting MenuSelecting Language Appendix Operating Wireless MouseInstallation Operating Wireless MouseCleaning the Projection Lens MaintenanceTemperature Warning Indicator AIR Filter Care and CleaningAppendix Lamp Replacement Indicator Lamp ReplacementLamp Replacement Monitor Timer Troubleshooting Function does not Remote Control UnitWireless Mouse Does not workTechnical Specifications Limited Warranty