Shutting down the projector

The projector automatically blanks the screen after no active source is detected for 30 minutes. This blank screen helps preserve the life of the pro- jector. The image returns when an active source is detected or a remote or keypad button is pressed. The Interactive Display on the projector indicates the shutdown status.

Screen Save

You can make the blank screen appear after five minutes by turning on Screen Save in the Settings>System menu. See page 33. There are six time options for the Screen Save feature. They range from five minutes to 30 min- utes with five minute intervals.

Power Save

The projector also has a Power Save feature that automatically turns the lamp off after no signals are detected for 5 minutes. After 3 additional min- utes with no signal, the projector powers down. If an active signal is received before the projector powers down, the image is displayed. You must press the Power button to display an image after 30 minutes have passed. When Power Save is enabled, Screen Save is disabled. See page 33.

Turning off the projector

To turn off the projector, press the Power button and verify that you want to turn the projector off by pressing the Power button again within 3 seconds. You can cancel the shutdown by not pressing the Power button a second time. The lamp turns off and the LED blinks green for 1 minute while the fans continue to run to cool the lamp. When the lamp has cooled, the LED lights green and the fans stop. Unplug the power cable to completely power off the projector.

Troubleshooting your setup

If your image appears correctly on the screen, skip to the next section (page 25). If it does not, troubleshoot the setup. The Interactive Display and LED on top of the projector indicate the state of the projector and can help you troubleshoot.

Table 1: LED behavior and meaning

LED color/behavior	Meaning

solid green	The projector is plugged in, or the projec-
	tor has been powered on and the soft-
	ware has initialized. The projector has
	been turned off and the fans have stopped.

blinking green	The power button has been pressed and
	the software is initializing, or the projec-
	tor is powering down and the fans are
	running to cool the lamp.

blinking red	A fan or lamp failure has occurred. Make
	sure the vents aren’t blocked (see
see page 42 for more information	page 22). Turn off the projector and wait
	one minute, then turn the projector on
	again. If the Replace Lamp message
	appears, replace the lamp and reset the
	lamp timer. Contact Technical Support if
	the problem persists.

solid red	An unidentifiable error: please contact
	Technical Support.

The following tables show common problems. In some cases, more than one possible solution is provided. Try the solutions in the order they are pre- sented. When the problem is solved, you can skip the additional solutions.