Displaying a video image
Remove the lens cap. | remove lens cap |
|
Press the Power button on the top of the projector or the remote. | press Power button |
| |
The LED flashes green and the fans start to run. When the lamp comes on, |
|
the startup screen is displayed and the LED is steady green. It can take a |
|
minute for the image to achieve full brightness. The Interactive Display on |
|
the projector indicates the startup status. |
|
?No startup screen? Get help on page 16. Plug in and turn on the video device.
turn on video device
The video device’s image should appear on the projection screen. If it doesn’t, press the Video button on the keypad.
Adjust the height of the projector by pressing the release button to extend |
|
|
the elevator foot. Rotate the leveling foot, if necessary. | adjust height | release button |
|
| |
|
| rotate |
| elevator | leveling |
| foot | |
| foot | |
|
| |
Position the projector the desired distance from the screen at a 90 degree | adjust distance |
|
angle to the screen. See page 42 for a table listing screen sizes and distances |
|
|
to the screen. |
|
|
computer 2 |
|
|
computer 1 | R | |
| ||
monitor out | network |
|
computer in | L | serial control |
| audio in | video 2 |
| video in | |
14