Out of Lamp Usage Time
The projector will be shut down automatically for safety issue. Please replace the lamp as soon
as possible.
If this warning message displays, the projector will shut down in 40 seconds. The lamp MUST be replaced before the projector will operate normally.
Replacing the lamp
• To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before changing the lamp.
•To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the lamp.
•To reduce the risk of injuries to fingers and damage to internal components, use caution when removing lamp glass that has shattered into sharp pieces.
•To reduce the risk of injuries to fingers and/or compromising image quality by touching the lens, do not touch the empty lamp compartment when the lamp is removed.
•This lamp contains mercury. Consult your local hazardous waste regulations to dispose of this lamp in a proper manner.
1.Turn the power off and disconnect the projector from the wall socket. If the lamp is hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled.
2. Turn the projector over. Then loosen the screw on the lamp cover.
3. Remove the lamp cover from the projector.
Do not turn the power on with the lamp cover removed.
Maintenance 57