English
Troubleshooting
Problem | Cause | Remedy | |
| There is no power from the power | Plug the power cable into the AC inlet on the | |
| cable. | rear of the projector, and plug the power | |
|
| cable into to the power outlet. If the power | |
|
| outlet has a switch, make sure that it is | |
The projector does |
| switched on. (See page 19) | |
|
| ||
The power switch is not in the on | Put the power switch in the on position. (See | ||
not turn on. | |||
position. | page 19) | ||
| |||
|
|
| |
| Attempting to turn the projector on | Wait until the cooling down process has | |
| again during the cooling process. | completed. | |
|
|
| |
| The lamp cover is not securely | Correctly attach the lamp cover. (See page | |
| attached. | 34) | |
|
|
| |
| The video source is not turned on or | Turn the video source on and check that the | |
| connected correctly. | signal cable is connected correctly. (See page | |
|
| 17) | |
|
|
| |
| The projector is not correctly | Check the connection. (See page 17) | |
No picture. | connected to the input source device. |
| |
|
|
| |
| The input signal has not been | Select the correct input signal with the | |
| correctly selected. | Source buttons on the remote control or | |
|
| SOURCE / ENTER on the projector. (See | |
|
| page 19) | |
|
|
| |
| The connection cables are not | Correctly connect the cables to the | |
Image is unstable. | securely connected to the projector or | appropriate terminals. (See page 17) | |
| the signal source. |
| |
|
|
| |
| The projection lens is not correctly | Adjust the focus of the lens using the focus | |
| focused. | ring. (See page 20) | |
Picture is blurred. |
|
| |
The projector and the screen are not | Adjust the projection angle and direction as | ||
| aligned properly. | well as the height of this unit if necessary. | |
|
| (See page 19) | |
|
|
| |
| The batteries are out of power. | Replace both of the batteries with new ones. | |
|
| (See page 9) | |
Remote control does |
|
| |
There is an obstacle between the | Remove the obstacle. (See page 13) | ||
not work correctly | remote control and the projector. |
| |
|
|
| |
| You are too far away from the | Stand within 8 meters (26.2 feet) of the | |
| projector. | projector. (See page 13) | |
|
|
|
36 Additional information