BenQ W10000, W9000 manual Installing the cable connector-panel cover, To install the cover

Installing the cable connector-panel cover

The cable connector-panel cover is used to cover those unsightly cables and connections in the rear of the projector after all of the cable connections have been done.

Important Notice: The following instructions are only for the projector which is intended to be installed near the floor or in a reachable location. If your projector is ceiling-mounted or out of your reach, it is a must to install or un-install the cable cover through a qualified technician’s help.

To install the cover:

1. Repeat Step 1~Step 3 in the "To clean the filter:"	2. Place a soft item on the desk for padding. Turn the
section. See page 32 for details.	projector upside-down so that you can locate the
	screws that hold the rear cover to the projector on
	both sides. Loosen the screws.

English

3.Turn the projector topside-up. Remove the rear cover.

4.Manage all the connected cables within the indentation of the cable connector-panel cover and attach it to the projector securely.

5. Turn the projector over again. Tighten the screws 6. Re-install the filter cover securely. to hold the cable connector-panel cover and the

projector on both sides.

7.The installation is finished.

Additional information 33