BenQ MX720 user manual Current, System, Status

Page 47

Function

6.
INFORMATIONmenu	Current
	Current
	System
	Status

Description

Source

Shows the current signal source.

Picture Mode

Shows the selected mode in the PICTURE menu.

Lamp Mode

Shows the current lamp mode.

Resolution

Shows the native resolution of the input signal.

3D Format

Shows the current 3D mode.

Color System

Shows input system format: NTSC, PAL, SECAM, YUV, or RGB.

Equivalent Lamp

Displays the number of hours the lamp has been used.

Firmware Version

Shows the firmware version of your projector.

Operation 47

Image 47

Contents

MX720/MW721 Digital Projector Table of contents Safety Instructions Important safety instructionsSafety Instructions 3000 m Feet Ceiling mounting the projector Introduction Projector featuresShipping contents Front/upper side Rear/lower side Projector exterior viewProjector Controls and functionsRemote control Replacing the remote control batteries Remote control effective rangeFront Ceiling Positioning your projectorChoosing a location Front TableMX720 Obtaining a preferred projected image sizeMW721 Connection ConnectionPlaying sound through the projector Connecting video source devicesConnecting audio Audio output port About the microphone inputStarting up the projector OperationFine-tuning the image clarity Adjusting the projected imageAdjusting the projection angle Auto-adjusting the imageCorrecting keystone Below is the overview of the OSD menu Using the menusIf you forget the password Using a security cable lockUtilizing the password function Setting a passwordDisabling the password function Entering the password recall procedureChanging the password Changing Color Space Switching input signalSelecting the aspect ratio Magnifying and searching for detailsMX720 MW721 About the aspect ratioGo to the Picture Picture Mode menu Using Wall ColorSelecting a picture mode Setting the User 1/User 2 modeSelecting a Color Temperature Fine-tuning the image quality in user modesAdjusting Brilliant Color 3D Color Management Setting a preferred color temperatureSelection Description Setting the presentation timerResetting current or all picture modes Top-Left Bottom-Left Top-Right Bottom-Right To cancel the timer, perform the following stepsRemote paging operations Freezing the imageOperating in a high altitude environment To activate the High Altitude ModeHiding the image Locking control keysTurning off the Power On/Off Ring Tone Adjusting the soundUsing the test pattern To select Blackboard or Whiteboard Using the teaching templatesShutting down the projector Direct power offMain menu Sub-menu Options Menu operationMenu system Basic Main menu Sub-menu Options System Setup Advanced Operation Description of each menu Fine Tuning 3D Color Picture menu Function Description Picture ModeTemperature Color Temperature Search Timer Installation SettingsReceiver System Setup Basic menu Function DescriptionOperation RemoteLamp System Setup Advanced menu Function Description HighAltitude AudioNetwork System Setup Advanced menu Function DescriptionReset All StandbyStatus CurrentSystem Care of the projector MaintenanceExtending lamp life Lamp informationGetting to know the lamp hour Status Message Timing of replacing the lampReplacing the lamp Connect the power and restart the projector Resetting the lamp timer Thermal events IndicatorsLight Status & Description Power events Lamp eventsTroubleshooting Projector specifications SpecificationsCeiling mount installation DimensionsKHz Timing chartSupported timing for PC input Supported timing for Hdmi Hdcp input Timing Supported timing for Component-YP bP r inputSupported timing for Video and S-Video inputs Disclaimer Warranty and Copyright informationLimited warranty Copyright

Related manuals

Manual 61 pages 54.58 Kb