Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option for setting up password security. The password can be set through the
You will be inconvenienced if you activate the password functionality and subsequently forget the password. Print out this manual (if necessary) and write the password you used in this manual, and keep the manual in a safe place for later recall.
Setting a password
Once a password has been set and activated, the projector cannot be used unless the correct password is entered every time the projector is started.
1. Press MENU/EXIT on the projector or remote control and then press 
/ 
until the System Setup : Advanced menu is highlighted.
2.Press 
to highlight Password and press MODE/ENTER. The Password page displays.
3.Highlight Change Password and press MODE/ENTER. The
Input Password page displays. | Back |
4.As the picture indicates, the four arrow keys ( 
, 
, 
, 
)
respectively represent 4 digits (1, 2, 3, 4). According to the password you desire to set, press the arrow keys on the remote control or projector to enter six digits for the password.
Confirm the new password by
Once the password is set, the OSD menu returns to the Password page.
IMPORTANT: The digits being input will display as asterisks
Password: __ __ __ __ __ __
5.Highlight Power On Lock and then press 
/ 
to select On.
6.Confirm the current password.
7.To leave the OSD menu, press MENU/EXIT.
If you forget the password
If the password function is activated, you will be asked to enter the six- digit password every time you turn on the projector. If you enter the wrong password, the password error message as pictured to the right displays lasting for three seconds, and the Input Password page follows. You can retry by entering another
If you enter an incorrect password 5 times in succession, the projector will automatically shut down in a short time.
Password Error
Please try again.
Using the projector | 25 |