English
Adjusting the projected image
Adjusting the projection angle
Remove the Back Foot Holder on the rear adjuster foot before adjusting the projection angle.
The projector is equipped with 1
1.Press the
of the projector. Once the image is positioned
where you want it, release the | 1 |
button to lock the foot in position.
2. Rotate the rear adjuster foot to fine tune the
horizontal angle. | 2 | |
To retract the foot, hold up the projector while | ||
| ||
pressing the |
| |
lower the projector. Screw the rear adjuster foot in |
| |
a reverse direction. |
|
If the projector is not placed on a flat surface or the screen and the projector are not perpendicular to each other, the projected image becomes trapezoidal. To correct this situation, see "Correcting keystone" on page 31 for details.
•Do not look into the lens while the lamp is on. The strong light from the lamp may cause damage to your eyes.
•Be careful when you press the adjuster button as it is close to the exhaust vent where hot air comes from.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the projector. Within 3 seconds, the
The current source information will be displayed in the upper left corner of the screen for 3 seconds.
•The screen will be blank while AUTO is functioning.
•This function is only available when COMPUTER signal (analog RGB) is selected.
Fine-tuning the image size and clarity
1. Adjust the projected image to the size that | 2. Then sharpen the image by rotating the | ||||||||
you need using the ZOOM ring. | FOCUS ring. | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FOCUS | FOCUS |
ZOOM | ZOOM |
30 Operation