Acer P1100, P1303W, P1203, P1200, P1206 manual Replacing the Lamp

Page 48

English

38

Replacing the Lamp

Use a screwdriver to remove the screw(s) from the cover, and then pull out the lamp.

The projector will detect the lamp life. You will be shown a warning message "Lamp is approaching the end of its useful life in full power operation. Replacement Suggested!" When you see this message, change the lamp as soon as possible. Make sure the projector has been cooling down for at least 30 minutes before changing the lamp.

Warning: The lamp compartment is hot! Allow it to cool down before changing the lamp.

3

1

2

1

2

54

To Change the Lamp

1Turn off the projector by pressing the power button.

2Allow the projector at least 30 mins to cool down.

3Disconnect the power cord.

4Remove the two screws on both sides of the projector at the same time. (Illustration #1)

5Push and slide the top cover towards the direction of the lens. (Illustration #2)

6Open the top cover. (Illustration #3)

7Remove the two screws that secure the lamp moduleX and pull up the lamp barY.(Illustration #4)

8Pull out the lamp module by force. (Illustration #5)

To replace the lamp module, reverse the previous step.

Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.

Image 48
Contents Page Page Information for your safety and comfort Turning the product off before cleaningUsing electrical power Additional safety information Product servicingPage Disposal instructions Mercury advisoryLamps contain Mercury, Dispose Properly To protect your hearing, follow these instructionsPrecautions Usage notesContents Regulations and safety notices Product Features IntroductionPackage Overview Projector Overview Projector OutlookFront / upper side Rear sideSee the contents in Turning the Projector On/Off section Temp Indicator LEDControl Panel # Icon Function Description Changes the active sourceRemote Control Layout HideRGB Connecting the Projector Getting StartedTurning the Projector On/Off Turning on the ProjectorLens cap Turning the projector off Adjusting the Projected Image Adjusting the Height of Projected ImageElevator foot release button Tilt adjusting wheel To raise the imageHow to optimize image size and distance P1100/P1200/P1203/P1206 seriesTop Maxscreensize P1303W series88 x 97 x Height Image P1303W series English Installation menu User ControlsAcer Empowering Technology Using the OSD menus Onscreen Display OSD MenusColor Image TintTo move the image left Correct 3D display DDD TriDef Media Player Trial Setting ManagementSecurity Lock User Startup Screen Timer AudioLanguage Troubleshooting Image Problems and SolutionsProblem Solution English English OSD Messages Condition Message ReminderProblems with the Projector Condition SolutionLED & Alarm Definition Listing LED MessagesReplacing the Lamp Ceiling Mount Installation Attach the ceiling bracket to the ceiling rod 60.0 mm Specifications DLPBelow items are for P1203/P1206/P1303W series only Compatibility modes VGA AnalogHdmi Digital PowerBook G4 119.85 77.2064.00 120Hz for 3D mode only 27.0059.94 31.47 576i 31.25FCC notice Operation conditionsRemarque à lintention des utilisateurs canadiens Declaration of Conformity for EU countriesRadio device regulatory notice General List of applicable countries Declaration of Conformity Oct Federal Communications Commission Declaration of Conformity
Related manuals
Manual 75 pages 5.75 Kb