Acer T111B, S5201M, PS-X11M manual LAN Setting, For P5403, LAN Reset, N243/PN-SX12

English

28

To connect your projector to the network:

1Take a RJ45 cable and connect one end to the LAN input jack of the projector and the other end to the RJ45 port.

2Enter the LAN Setting menu. The "Enter Administrator Password" dialogue box is displayed.

3Enter "Administrator Password". The next level menu is displayed.

The factory default of "Administrator Password" is "1234". You can change it in the Setting > Security > Administrator Password menu.

4	Select LAN in this menu and press		to select "On".
5	Make sure DHCP is on, and press		to select Apply and
	press	.
6	Re-enter the menu and note down the IP address
LAN Setting	displayed in the row of Projector IP Address.
(for P5403/
N243/PN-SX12)If your are not in a DHCP environment, set DHCP to "Off" and
contact your ITS administrator for information on Projector IP
Address, Subnet Mask, Default Gateway, and DNS Server.

1 Press to select Projector IP Address and press .

2 Press	to move the cursor and press	to
enter the digits.

3When you finish, press MENU to save and exit the menu.

4Repeat steps 1-3 to input addresses for Subnet Mask, Default Gateway, DNS server.

5Press to highlight Apply and press .

	To control the projector remotely:
	1 Enter the Projector IP address in the address bar of the
	web browser on your computer.
	2 The remote network operation page is displayed.You can
	control the projector by using this page. For details, see
	the notes following this table.
LAN Reset	Press	after choosing "Yes" to return all items on the Tools
(for P5403/	page to the default settings.
N243/PN-SX12)
LAN	• The default value is "Off". Choose "On" to enable the
(for S5201M/	LAN connection.
T111B/PS-X11M)