25
| Security |
|
| This projector provides a useful security function for the | |
| administrator to manage the projector. | |
| Press | to change the "Security" setting. If the security |
| function is enabled, your must enter "Administrator | |
Security | Password" first before changing the security setting. | |
The factory default of "Administrator Password" is "1234".
•Select "On" to enable the security function. You have to enter password depending on the "Security Mode". Please refer to "User Password" section for details.
•If "Off" is selected, you can switch on the projector without password.
Timeout (Min.)
Once "Security" is set to "On", you can set timeout function.
•Press 
to select timeout duration.
•The range is from 10 to 990 minutes.
•When time is up, the projector will request you to enter the password again.
•The factory default setting of "Timeout (Min.)" is "Off".
•Once the security function is enabled, the projector will request you to enter password when switching on the projector. Both "User Password" and "Administrator Password" can be accepted for this dialogue.
User Password
•Press 
to set up or change "User Password".
•Use the numerical keys on the remote control to set the password and press "MENU" to confirm.
•To delete the digits, Press 
.
•Enter the password again when you see "Confirm Password" displayed.
•The password should be 4~8 digits in length.
•If you select "Request password only after plugging power cord", you are requested to input the password every time the power cord is plugged.
•If you select "Always request password while projector turns on", you are requested to input the password every time the projector is turned on.