Acer H5360 manual Problems with the Projector, Condition Solution

27

9	Image is too small	•	Adjust the zoom lever on the front of the projector.
	or too large	•	Move the projector closer to or further from the
			screen.
		•	Press "MENU" on the remote control. Go to "Image
			--> Aspect Ratio" and try different settings or
			press"Aspect Ratio" on the remote control to adjust
			directly.
10	Image has slanted	•	If possible, reposition the projector so that it is
	sides		centered on the screen.
		•	Press the "Keystone / " button on the remote
			control until the sides are vertical.
		•	Press "MENU" on the remote control. Go to "Image -
			-> Auto Keystone" and choose "Off" on the OSD, if
			"Keystone" button is not available on the remote
			control.
11	Image is reversed	•	Select "Image --> Projection" on the OSD and adjust
			the projection direction.
Problems with the Projector
#	Condition			Solution
1	The projector stops responding			If possible, turn off the projector, then
	to all controls			unplug the power cord and wait at least 30
				seconds before reconnecting power.
2	Lamp burns out or makes a			When the lamp reaches the end of its useful
	popping sound			life, it will burn out and may make a loud
				popping sound. If this happens, the projector
				will not turn on until the lamp module has
				been replaced. To replace the lamp, follow
				the procedures in the "Replacing the Lamp"
				section.

English