Installation Set Up
A : Horizontal scan inversion
Three connectors are used, one for each horizontal deflection coil. When changing the horizontal scan, insure that all three connectors are set in the same position. See position of the connectors for the corresponding projector configuration.
B : Vertical scan inversion
Three connectors are used, one for each vertical deflection coil. When changing the vertical scan, insure that all three connectors are set in the same position. See position of the connectors for the corresponding projector configuration.
Top view of the connectors; upper three connectors for horizontal scan inversion, lower three for vertical scan inversion.
Horizont al scan connectors
Vertical scan |
connectors |
Front / Table
Front / Ceiling
Rear / Table
Rear / Ceiling
C : Convergence connectors
Three connectors are used. The position of these connectors has to be changed when switching from one configuration to another. With an open chassis, for a
Contact side
the connectors must be plugged in with the contacts upwards (away from the tubes). For a
After scan inversion, close the chassis and close the top cover. Reconnect the power cord to the wall outlet.
Note
Switching over from floor to ceiling or vice versa requires a complete readjustment of picture geometry and convergence.
Check of the correct connector position
Note : this check procedure can only be done after power (mains) connection. So, first continue with the projector set up and the connections and then return to this checking procedure.
Switch on the BARCODATA 708 and press ADJUST to start up the adjustment mode. Select with the control disk 'Service' and press ENTER. The service menu will be displayed. Select 'PROJECTOR SET UP' and press ENTER. Select 'IDENTIFICATION' and press ENTER. On this screen, information is given about the projectors configuration.
Configuration when leaving the factory : ceiling/front configuration.
Follow next procedure to check the configuration :
-switch on the projector.
-the projector starts up on the last selected source.
-press the ADJUST key.
-highlight 'service' with the control disk and press ENTER. The 'service mode menu' will be displayed
-select with the control disk 'Projector set up' and press ENTER. The 'Projector set up menu' will be displayed.
-Select with the control disk 'Identification' and press ENTER.
The projector displays the Identification screen
This screen gives information about the projector configuration in the subject 'config.'.
5975987A BARCODATA 708 260597
ADJUSTMENT MODE |
Select a path from |
below: |
GUIDED |
RANDOM ACCESS |
INSTALLATION |
SERVICE |
IRIS |
source 1 |
SERVICE MODE |
PROJECTOR |
MEMORY MANAGEMENT |
COMMON SETTINGS |
I2C DIAGNOSTICS |
PROJECTOR |
IDENTIFICATION |
TOTAL RUN TIME |
CHANGE PASSWORD |
CHANGE LANGUAGE |
CHANGE PROJECTOR ADDRESS |
CHANGE BAUDRATE |
POWER UP MODE : operating |
BARCO LOGO |
DATA 708
Proj. address : 001
Soft. Version : 5.00
Config. : Ceiling
front
Baudrate PC : 9600
Text : ON
Serial No. : 10359852