Installation Adjustments
Optical lens focusing
The optical focusing procedure is performed separately for each lens. The appropriate CRT will be switched on as the user proceeds through the optical focusing adjustment sequence.
Each lens has two focus adjustment points, one at the rear of the lens and one at the front. The center of the projected image is focused by loosening the wing nut at the rear end of the lens and rotating the lens barrel until the center of the image is clearly focused. The corners of the projected image are focused by loosening the wing nut at the front end of the lens and rotating the lens barrel until the corners of the image are clearly focused. Repetition of these adjustments may be necessary to optimize optical focusing.
Press ENTER key to continue.
ENTER continues to Raster centering.
EXIT returns to scheimpfug adjustment
ADJUST returns to operational mode.
Electrical focusing
The electrical focus for red, green and blue is factory preset. When they have to be readjusted, follow the procedure as described below:
-Ensure the lenses are correctly focused.
-Open the top cover.
-Adjust separately the focus control for red, green and blue for the sharpest image on the screen.
OPTICAL LENS FOCUSING
1.LOOSEN THE NUT ON THE REAR OF THE XXXX LENS, ROTATE THE LENS BARREL TO FOCUS THE CENTER OF THE IMAGE,
THEN TIGHTEN THE NUT
2.LOOSEN THE NUT ON THE FRONT OF THE XXXX LENS AND ROTATE THE FRONT SECTION OF THE LENS TO FOCUS THE CORNERS OF THE IMAGE, THEN TIGHTEN THE NUT.
<ENTER> to continue <EXIT> to return
XXXX = respectively red, green and blue.
Center focusing
Corner focusing
Electrical focus
Red Green Blue
5975987A BARCODATA 708 260597 |
| 7 - 5 |
|